powder-zones snowboarding anatomy
Board Anatomy Nose - the nose is the end that usually point’s downhill Tail - the tail is the end that usually points uphill Toe edge - the side of the board where your toes are Heel edge - the side of the board where your heels are binding - the thing that binds your foot to the board. Regular vs. Goofy Picture yourself sliding downhill sideways. Which side is facing downhill, you’re right or left? Alternatively, imagine yourself sliding across the kitchen floor in your socks. Which foot is forward? If you answered left, you’re “regular”. If you answered right, you’re “goofy”.
On a snowboard, your feet are not perfectly pointed straight toward the toe edge, they are slightly angled either to the left (regular) or to the right (goofy). Your “leading foot” (the foot that goes down the hill first) for a regular person, this is the left foot, for a goofy person, it’s the right. The board pictured above is a regular board. On a goofy board, the nose is on the right and the tail is on the left. Riding the Board The first unusual factor you need to get used to thinking about is that you can face any direction while riding downhill on a snowboard.
You can go down the slope backwards, that is, with your toes pointed uphill and your back in the direction in which you’re traveling. You can go down the hill nose end first or tail end first. You can go downhill facing downhill, or you can do anything in between. Wicked hey? The uphill edge bare in mind while you are snowboarding, always put pressure on the uphill edge of the board. So, if you are going down the mountain backwards, that is, facing uphill, your pressure will be on your toes. This way of facing the mountain is called “toeside” for obvious reasons. If you are going down the mountain facing downhill, your pressure will be on your heels. This is called “heel side”. DON’T put pressure on the downhill edge. It will cause you to fall over.
Think about it. If you are heel side (that is, traveling downhill and facing downhill) and you dig the downhill edge (the toe edge) into the snow, what do you think will happen? The board will stop and you will keep going, causing you to tumble over your board and fall flat on your face. Similarly, if you are toeside (traveling downhill backwards) and your heel edge digs in, what is going to happen? Your board will stop and you won’t, causing your backside to slam into the ground. And guess what this is known as ????????? Balancing front-back The balance point is the center of your weight relative to the surface of the board. Try this: at a standstill, position the board so that it is perpendicular to the slope and you are facing downhill. Now, tilt the toe edge of the board up and down using your ankles, move yourself front and back until you find the spot where you won’t tip over. That’s your balance point. The balance point changes with the softness of the snow because in soft snow, you’ll have to tilt your board away from the incline more so than you would on hard-packed snow. Try going heel side slowly down an incline by reducing the pressure applied by your heels. Balancing left-right For the most part, try to keep your weight evenly distributed between your two feet.
You don’t want to put more weight on the uphill foot. Why not? The surface of the board under the leading (downhill) foot is largely what steers you. Just think of a sled going down a hill. The steering is in the front; friction on the sides of these blades will make it turn. If that analogy didn’t work for you, then consider this one: Ever done a pop-a-wheelie on your bike as a kid? What happens when you steer while your front wheel is in the air? It has no effect on your direction, right? No control. Same thing with a snowboard, if there is no pressure on the leading end (the downhill foot), you have no steering. Stopping a stop is a lot like a hockey-stop on ice skates. You bring the board perpendicular to the slope and dig the uphill edge in. If you are heel side (if you are facing downhill) you stop by digging your heels in. If you are toeside, (if you are facing uphill) you stop by digging your toes in.
Slowing down is basically the same thing. It’s just that when you want to stop you apply a lot of pressure fast. At the same time, you’ll be balancing your weight (shifting your balance point) so you don’t upset your position to the point where you tip over. Practice stopping heel side. Then practice stopping toeside. Turning Okay, this part is important, so pay attention. Start with your board perpendicular to (that is, horizontal across) the slope and then apply less and less pressure to the edge and see what happens. The leading foot tends to go downhill. If you stay in this position, with the lead foot downhill and the board parallel with the slope, you’ll go fast.
Surfing Longboards Articles
Surfing Longboards Books